Linear optical axis is suitable for rust-prone environment or bad environment because of its own characteristics of corrosion resistance and wear resistance. It is widely used in industrial robots and moving parts of automatic sliding system devices. Due to the hollow structure of the linear optical axis, to a large extent, the weight of the equipment is also reduced and the structure is simplified. Its internal structure is suitable for penetrating measurement wires, compressed air, adding lubricating oil and hydraulic oil, or used in robot arms. The material of linear optical axis is generally better to use bearing steel, followed by medium carbon steel, and low carbon steel slightly worse. Of course there will be differences in prices. Its surface hardness is generally above HRC58 (the sample parameters of most manufacturers will be marked as HRC62 plus or minus 2. How to actually need to be verified, but more than 58 will meet most applications), and more importantly, the full surface hardening depth and For the uniformity of hardness, if the hardness test reaches plus or minus 2 degrees Rockwell, it is considered qualified. The hardening depth is between 1.5~5mm (depending on the outer diameter). The medium and low frequency quenching may lead to too deep hardening, which has a negative impact on the strength. The high frequency hardening is generally shallow, which can balance the hardness and strength. .
https://www.skivingtubelw.com/
