In order to improve the assembly quality of the stainless steel piston rod, the clearance between the piston and the cylinder should be ensured before installation. Also check if the tolerances of the cylinder liner are qualified. After the equipment cylinder rod is inspected, when installing a new sealing rubber ring, the sealing rubber ring should be flat and not twisted. And in this process, no oil should be adhered to prevent the rubber from becoming soft, and the elasticity is weakened and the sealing effect is lost. At the same time, an appropriate amount of sealant can be applied around the seal ring, and it should be continuous, uniform and uninterrupted when applied.
The stainless steel piston rod puts the cylinder into the cylinder block, and presses the cylinder sleeve into position evenly with both hands. And check that each cylinder is higher than the upper plane height of the cylinder to avoid deformation or poor sealing of the cylinder head when tightening the cylinder bolts. If there are conditions, the cylinder head gasket and the cylinder head should be installed without leakage.
Stainless steel piston rod blank shape
In general, if the piston rod is produced in small batches, it is best to select a cylindrical blank. However, since different parts will have different processing precision requirements, it is necessary to set the scale tolerance level of the forging to 8-12.
Blank scale of stainless steel piston rod
Because the blank is made by free casting, it should be based on the scale requirements of the piston rod part drawing and the actual processing requirements.www.skivingtubelw.com
