Cold drawn pipes have the characteristics of no oxide layer on the inner and outer walls, high pressure without leakage, high precision, high finish, cold bending without deformation, flaring and flattening without cracks, and anti-rust treatment on the surface. They are mainly used for mechanical structures and hydraulic equipment. And pneumatic or hydraulic components of automobiles and motorcycles, such as cylinders or oil cylinders.
The first stage is the shedding cutting stage. In this constant-pressure honing, due to the rough hole wall at the beginning, the contact area between the whetstone and the hole wall is small, the contact pressure is large, and the protruding part of the hole wall is quickly ground away. However, due to the high contact pressure on the surface of the whetstone and the wear of the whetstone binder by the cutting chips, the bonding strength between the abrasive particles and the binder is reduced. Therefore, some abrasive particles fall off by themselves under the action of the cutting pressure, and the whetstone surface is exposed. Abrasive particles, this is the self-sharpening of whetstone.
The second stage is the crushing and cutting stage. With the progress of honing, the surface of the hole becomes more and more polished, the contact area with the oil stone becomes larger and larger, the contact pressure per unit area decreases, and the cutting efficiency decreases. At the same time, the cut chips are small and thin, and the wear of the binder by these chips is also very small. Therefore, the whetstone abrasive particles fall off very little. At this time, the grinding is not based on new abrasive particles, but is cut by the tip of the abrasive particles. Therefore, the tip of the abrasive particles is heavily loaded, and the abrasive particles are easily broken and shattered to form new cutting edges.
The third stage is the blockage cutting stage. When the honing continues, the contact area between the oilstone and the hole surface becomes larger and larger, and the extremely fine chips accumulate between the oilstone and the hole wall and are not easily removed, causing the oilstone to block and become very smooth. Therefore, the cutting ability of oilstone is extremely low, which is equivalent to polishing. If you continue to honing, the oilstone will become severely clogged and cause cohesive clogging. The oilstone will completely lose its cutting ability and generate severe heat, which will affect the accuracy and surface roughness of the holes.
Cold drawn pipes are processed by rolling. Because the surface layer has residual surface stress, it helps to close the micro cracks on the surface and hinder the expansion of corrosion. Thereby improving the surface corrosion resistance, and can delay the generation or expansion of fatigue cracks, thereby improving the fatigue strength of cold drawn pipes. Through roll forming, a cold work hardened layer is formed on the rolled surface, which reduces the elastic and plastic deformation of the contact surface of the grinding pair, thereby improving the wear resistance of the inner wall of the cold drawn pipe and avoiding burns caused by grinding. . After rolling, the surface roughness value is reduced, which can improve the matching properties.
https://www.skivingtubelw.com/
