Method for improving finish of honing tube

Feb 09, 2020

Leave a message

A type of steel pipe generally obtained by honing is called honing pipe. In the honing process of the honing tube, the use of honing tools is relatively common, and one of the more commonly used is the honing gear.

The honing gear is composed of a base body and an abrasive material. It is used for honing, mainly to remove impurities and burrs on the surface of the material, so as to improve the surface finish. However, we also need to pay attention to the following points when using this kind of honing tool:

1. The stroke of the equipment should not exceed the width range during honing; otherwise, the honing gear may be seriously damaged.

In the control of honing amount, its value should be controlled within a reasonable range. And for the control of honing time, it is the same requirement, it is recommended to be about two minutes.

3. The material of the honing gear is relatively brittle, so it is forbidden to beat it, so as not to damage it and not use it.

Regarding the question of how to improve the surface finish of the honing tube, it is not difficult to achieve the goal, because it can be started from the honing process and then realized. Further, by selecting a suitable honing oilstone and controlling the roughness so that it is within the normal allowable range, the above requirements can be achieved. However, in some cases, it is necessary to pay attention to the material used for the honing tube and the hardness of the material, so that it can be comprehensively considered to avoid problems.

Send Inquiry