Plastic deformation of cold drawn tube

Sep 09, 2020

Leave a message

The outer diameter of the cold-drawn tube can reach 6mm, the wall thickness can reach 0.25mm, the outer diameter of the thin-walled tube can reach 5mm, and the wall thickness is less than 0.25mm. The accuracy and surface quality are significantly better than the hot-rolled (expanded) tube, but it is affected by the process Restrictions, its caliber and length are subject to certain restrictions.

  The cold-drawn pipe processing steel tube is work hardened. The metal deforms plastically during cold drawing, and multiple slip systems start inside the crystal. The dislocation movements intercept each other. Many dislocations are pinned, causing dislocations to accumulate and at the same time the dislocation source stops. The above-mentioned series of processes lead to a decrease in the dislocation mobility, and the density of dislocations in the crystal increases significantly. When the plastic deformation further occurs, the stress increases enough to start the movement of the pinned dislocations, the screw dislocations intersect and slip, and the blade dislocations cannot intersect and slip, so that the dislocations intersect and the fixed order increases.

https://www.skivingtubelw.com/

Send Inquiry