Processing method of micro-deformation of cylinder piston rod

Mar 25, 2021

Leave a message

Due to the high nitriding temperature, the piston rod will occasionally deform to a certain extent after nitriding. At this time, the piston rod has reached the size requirements of the finished product, and the surface hardness is very high. It cannot be refined by machining methods, and can only be calibrated. The straight method controls the amount of deformation within a reasonable range. 1. The principle of micro-deformation straightening The commonly used pressure straightening machine, whether it is hot or cold, its straightening accuracy is affected by man-made, and it can reach 1~2mm. Usually, the one-sided product after the piston rod nitriding treatment has 0.1~ The bending deformation amount of 0.3mm, such a slight deformation amount can not meet the requirements for straightening with a pressure straightening machine. Through bold attempts and actual verification, we use the method of bending and percussion vibration for straightening. Straightening principle: The workpiece resonates under the action of the periodic external force applied by the exciter ── the exciting force. The alternating stress on each part of the workpiece is superimposed with the residual stress inside, causing the workpiece to yield locally, causing tiny Plastic deformation reduces the residual stress in the workpiece, the redistribution tends to be uniform and enhances the deformation resistance of the metal matrix, thereby achieving the purpose of improving the geometric accuracy and stability of the workpiece. This process is called vibration stabilization. The vibration stabilization process is usually used to stabilize parts, and it is borrowed here as the straightening of piston rod parts. 2. Straightening method for slight deformation 1. Use 2 pieces of V-shaped iron to support both ends of the piston rod, set a dial indicator in the middle, turn the piston rod by hand, record the up and down runout value of the piston rod, and mark the high and low points On the pole. 2. Use the pressure plate bolt to press the high point down by 5-10mm, keep it still, and knock the shaft with a copper rod several times (see Figure 2) to stabilize the bending stress. The hardness of the copper rod is 130-160HB, and the hardness of the piston rod is 280-300HB. Because the copper rod is softer than the piston rod, the surface of the piston rod will not be deformed when hit. 3. Remove the pressure plate and recheck the beating of the piston rod according to Figure 1. If the beating exceeds the limit, it can be calibrated again until it is qualified, during which good patience and experience are required. A batch of piston rods were straightened by this method, and after being placed for 5 days, the runout value was rechecked, and there was no rebound phenomenon, indicating that this straightening method is feasible.

https://www.skivingtubelw.com/

Send Inquiry