Contact Us
Contact: Mrs.Yao
Contact: Mr.Zhou
Tel: +86-510-83831286
Fax: +86-0510-83831286
Address: Yaxi industrial Park, Luoshe Town, Wuxi City, Jiangsu
Home > Exhibition > Content
Reasons and control of precision cold drawn tube peeling
Aug 24, 2018

1, the cause of inclusions

The main chemical components of the inclusions are chemical elements such as oxygen, silicon, aluminum, and calcium, and the main component is the slag of the crystallizer. The inclusions are exposed to the surface of the steel sheet for a long time during the rolling of the steel sheet, causing skin defects.

The root cause is also in the continuous casting process of cold drawing and refining. By adjusting the chemical composition of the steel, reducing the amount of shielding gas, using a suitable tundish insertion depth, a reasonable secondary cooling system, and replacing the mold flux and The effective control of the liquid level fluctuation of the crystallizer optimizes the steelmaking and continuous casting process, so that the defects are controlled. The most effective effect of reducing the total argon blowing amount on the slag or inclusion during the cold drawing continuous casting process is most effective. .

2, the cause of bubbles

The peeling defect of the cold drawn tube type is mainly because the molten steel contains a relatively high content of gas elements, and the molten steel gathers under the surface of the steel sheet before the condensation of the steel to form subcutaneous bubbles, and is pressed during the rolling process of the steel sheet. Finally, a skin defect was formed. It is generally believed that some honeycomb-shaped bubbles are prone to occur during hot rolling of steel sheets, and the reason for the formation of bubbles is that some of the richer elements of oxygen, hydrogen, nitrogen, carbon, etc. are in the slab during the condensation process of the cold drawn steel. The surface is enriched, and under certain conditions, bubbles form. The bubbles on the surface of the steel are crushed by some force during the rolling process, resulting in skin-like defects.

Previous: Factors that cause cylinders to crawl or slip

Next: Precision cold drawn steel pipe surface quality defects