What are the methods for improving the tensile strength of precision steel pipes

Jul 22, 2019

Leave a message

First, precision steel pipes can also be replaced by eddy current testing. The test pressure or eddy current test comparison sample size should meet the requirements of GB 3092. The mechanical properties of steel are important indicators to ensure the ultimate performance (mechanical properties) of steel, which depends on the chemical composition of the steel and the heat treatment system. In the steel pipe standard, according to different use requirements, tensile properties (precision strength of steel pipe, yield strength or precision steel pipe, elongation), hardness and toughness index, and high and low temperature performance required by users are specified.

Second, the tensile strength of precision steel pipe (σb): the maximum force (Fb) that the specimen is subjected to during the drawing process, and the stress (σ) obtained from the original cross-sectional area (So) of the sample. It is called the tensile strength (σb) of precision steel pipe and its unit is N/mm2 (MPa). It represents the maximum ability of a metal material to resist damage under tensile forces. Where: Fb--the maximum force to be taken when the sample is broken, N (Newton); So--the original cross-sectional area of the sample, mm2. Precision steel pipe (σs): A metal material with a yielding phenomenon. The strength of the sample during the drawing process is not increased (maintained constant) and the stress can be extended. If the force drops, the upper and lower precision steel pipes should be distinguished. The unit of precision steel pipe is N/mm2 (MPa). Upper precision steel tube (σsu): the maximum stress before the sample yields and the first drop of force; the lower precision steel tube (σsl): the minimum stress in the yielding stage when the initial transient effect is not counted. Where: Fs--the yield force (constant) during the tensile process of the specimen, N (Newton) So--the original cross-sectional area of the specimen, mm2. Elongation after break: (σ) In the tensile test, the percentage of the increase in the gauge length and the length of the original gauge length after the sample is broken is called the elongation. 

Third, expressed in σ, the unit is %. Where: L1--the length of the gauge length after the sample is broken, mm; L0--the original gauge length of the sample, mm. Section Shrinkage: (ψ) In the tensile test, the maximum reduction of the cross-sectional area of the reduced diameter after the sample is broken and the percentage of the original cross-sectional area is called the area shrinkage. Expressed in ψ, the unit is %. Where: S0--the original cross-sectional area of the sample, mm2; S1--the minimum cross-sectional area at the reduced diameter after the sample is broken, mm2. Hardness index: The ability of a metal material to resist the indentation of a hard object, called hardness. According to the test method and the scope of application, the hardness can be divided into Brinell hardness, Rockwell hardness, Vickers hardness, Shore hardness, microhardness and high temperature hardness. Commonly used for pipes are Brinell, Rockwell and Vickers hardness. Brinell hardness (HB): press the steel ball or carbide ball with a certain diameter into the surface of the sample with the specified test force (F). After the specified holding time, remove the test force and measure the diameter of the indentation on the surface of the sample. (L). The Brinell hardness value is the quotient obtained by dividing the test force by the spherical surface area of the indentation. It is expressed by HBS (steel ball) and the unit is N/mm2 (MPa).

 www.skivingtubelw.com


Send Inquiry