Production Process And Plastic Deformation Of Cold Drawn Pipe

Nov 28, 2020

Leave a message

Cold drawn pipe is a kind of steel pipe when it is used, and it is classified according to its production process during operation, which is mainly different from hot rolled (expanded) pipe. In the process of expanding the diameter of the blank or raw material pipe, it is processed by multiple passes of cold drawing, usually on a single-chain or double-chain cold drawing machine of 0.5-100T. Cold rolled (dial) steel pipes are divided into general steel pipes, low and medium pressure boiler steel pipes, high pressure boiler steel pipes, alloy steel pipes, stainless steel pipes, petroleum cracking pipes, machined pipes, thick-walled pipes, small-diameter cold drawn pipes with internal molds and other steel pipes , Also includes carbon thin-wall steel pipe, alloy thin-wall steel pipe, stainless thin-wall steel pipe, special-shaped steel pipe. The outer diameter of cold drawn pipes can reach 6mm, the wall thickness can reach 0.25mm, and the outer diameter of thin-walled pipes can reach 5mm. The wall thickness is less than 0.25mm. The precision and surface quality are obviously better than that of hot rolled (expanded) pipes. Restrictions, its caliber and length are subject to certain restrictions. The cold-drawn pipe processing steel pipe is work hardened. During cold drawing, the metal undergoes plastic deformation, multiple slip systems inside the crystal are activated, and the dislocation movement intercepts each other, and many dislocations are pinned, causing dislocation accumulation, and the dislocation source stops moving at the same time. The above-mentioned series of processes lead to a decrease in the mobility of dislocations and a significant increase in the dislocation density in the crystal. When the plastic deformation further occurs, the stress increases and is enough to make the pinned dislocations start to move, the screw dislocations slip, and the edge dislocations cannot slip, so that the dislocations are intersected and the immovable order increases. Therefore, the internal dislocation density of the metal is increased by cold drawing, and the mobility of the dislocation is reduced. It is difficult to generate and move the dislocation, and therefore the hardness and strength of the metal material are improved. This is the metallurgical principle of cold drawing. During cold drawing, the steel pipe passes through a mold of a certain shape and size under the action of force, and plastic deformation occurs. At present, the drawing methods in production can be roughly divided into three types: reduced-diameter drawing, reduced outer wall drawing and reduced inner wall drawing. During cold drawing, the steel pipe is subjected to drawing force, positive pressure and friction. Corresponding deformations mostly go through the three stages of diameter reduction, wall reduction and sizing, and corresponding stresses are generated in the deformation zone. The axial direction is tensile stress, the radial and circumferential directions are compressive stresses. The metal is in one direction during the process of drawing. Tension and two-way compression stress state, which are the basic mechanical characteristics of the deformation process of cold drawn pipes.

https://www.skivingtubelw.com

Send Inquiry