In the process of operation, the high precision honing pipe has surface residual compressive stress on the surface layer, and closes the micro crack of the surface to a certain extent, so as to avoid the expansion of the erosion effect, thereby improving the surface corrosion resistance and slowing the crack. Generate or expand. Through roll forming, the rolling surface forms a cold hardening layer, which reduces the elastic and plastic deformation of the grinding contact surface, thereby improving the wear resistance of the inner wall of the honing pipe to avoid damage caused by grinding. After rolling, the surface roughness value is reduced to improve the properties of the honing tube.
How to do the high precision honing pipe constant pressure?
The first stage is the shedding cutting stage. At the beginning, due to the rough wall of the hole, the contact area between the oil stone and the hole wall is small, the contact pressure is large, and the convex portion of the hole wall is quickly worn away. However, due to the high contact pressure on the surface of the oil stone and the wear of the oil-and-binder binder by the chips, the bonding strength between the abrasive particles and the binder is reduced. Therefore, some of the abrasive grains fall off under the action of the cutting pressure, and the surface of the oil stone is exposed. Abrasive grain, this is the oil stone self-sharp.
The second stage is the crushing and cutting stage. As the honing progresses, the surface of the hole becomes more and more light, the contact area with the oil stone becomes larger and larger, the contact pressure per unit area decreases, and the cutting efficiency decreases. At the same time, the cut chips are small and fine, and the wear of these chips on the adhesive is also small. Therefore, the oil stone abrasive grains are rarely peeled off, and the grinding is not performed by the new abrasive grains but by the abrasive grain tips. Therefore, the tip of the abrasive grain is very heavy, and the abrasive grain is easily broken and broken to form a new cutting edge.
The third stage is the plugging and cutting stage. When the honing continues, the contact area between the surface of the oil stone and the hole is getting larger and larger. The extremely fine chips accumulate between the oil stone and the hole wall, which is difficult to remove, causing the oil stone to become clogged and become very smooth. Therefore, the oil stone cutting ability is extremely low, which is equivalent to polishing.
www.skivingtubelw.com
