How to ensure good forming quality of cold drawn pipe

Jan 28, 2021

Leave a message

If you want to ensure good forming quality for cold drawn pipes, you not only need to choose a suitable forming roll pass design, but also have certain adjustment techniques. Usually the cold-drawn pipe is formed from the first pass to the last pass, and the connection line of the lowest point of each roll pass is called the forming bottom line. The bottom line can be adjusted by adjusting the height of the lower roller slider. To ensure that the forming bottom line is a horizontal line during the forming process, the level of the bottom line can be determined by the method of hanging the line, and then the upper roller is adjusted to a certain position according to the specifications of the welded steel pipe.

It should be noted that during the adjustment process, it is necessary to ensure that the forming volume of each roll is uniform to avoid the impact of uneven force on the performance of the unit. The forming vertical roll must be adjusted horizontally and axially to ensure that the pass and center are in In a straight line. We must know that the shape of the formed steel pipe directly affects the welding quality of the later cold drawn pipe.

In order to ensure the welding quality of cold drawn pipes, it is generally necessary to perform corresponding processing and finishing of the welding part of the workpiece before welding. It can be cut by gas or by cutting, generally bevel, sometimes curved. For example, two cold drawn pipes with a thickness of 10mm should be butt welded together. In order to make the welding seam firm, a chamfer is milled on the edge of the plate. This is called beveling.

In actual production, because the thickness of the cold drawn pipe itself is different, and the welding quality is also different, the requirements for the form of the welded joint and the shape of the groove are also different. Under normal circumstances, the groove form can be divided into K type, V type, I type, U type and X type. At the same time, we call the groove surface on the workpiece to be welded as the groove surface.

In addition, when processing, for cold drawn pipes, it is also necessary to select an appropriate bevel surface angle and bevel angle. The angle between the end face of the bevel to be processed and the bevel surface is called the bevel surface angle, and the angle between the two bevel surfaces is called the bevel angle. In addition, the spacing must be considered. The gap between the roots of the joint before welding is called the root gap. Its function is to ensure the penetration of the root during bottom welding. The root gap is also called the assembly gap.

https://www.skivingtubelw.com/

Send Inquiry