Methods to solve the defects caused by cold drawn steel pipes

Jan 26, 2021

Leave a message

In the actual production of cold drawn steel pipes, it is often affected by various factors. That is to say, the defects caused by cold drawn steel pipes are often caused by a combination of several factors. For example, a narrow V-shaped port does not necessarily produce over-fired oxide, unless the extrusion volume is slightly less than the normal required value.

If the amount of extrusion is too small, it may be caused by the slightly narrow slitting width of the steel strip, or the wear of tooling, and improper installation of equipment. In addition, the welding defects of cold drawn steel pipes may also be caused by reasons outside the welding zone. For example, cold welding may be caused by cavitation (evacuation) of the cooling pump, which cannot sufficiently cool the magnetic bar, and the magnetic bar becomes hot instantly. In this way, the effect of the current concentrated in the V-shaped port will be weakened, the current will be conducted along the back of the steel pipe, the heat of the V-shaped port will be reduced, and cold welding will occur.

There are many processes for cold drawn steel pipe processing, and these different processes have different influences. Just like mirror polishing, brushed surface and other processing to make the surface of the guardrail more beautiful.

Cold drawn steel pipes can be combined with solar photovoltaic power generation systems, solar vacuum tubes, etc. during processing. Such processing technology can be cold drawn steel pipes with solar energy effects, and because they are used with super mechanical properties and corrosion resistance Stainless steel is the raw material, so the service life will be longer.

When the cold drawn steel pipe is processed, the structure of the elbow of the main surface pipe must be smooth and non-marking. In addition, the stainless steel pipe fixed on the ground should also be kept perpendicular to the main surface pipe, because the hardness of stainless steel is relatively large. If there is a certain angle, it is likely to affect the subsequent installation. And the vertical stainless steel pipes should be kept parallel to this time to minimize the error in spacing.

https://www.skivingtubelw.com/

Send Inquiry