Mechanics principle of cold drawn steel pipe

Jan 24, 2021

Leave a message

Cold-drawn steel pipes are made on the basis of cold-drawn steel pipes. Because the temperature of cold-drawn steel pipes is relatively high, the effect of long-term use and continuous development is relatively large. It can be said that cold-drawn steel pipes are used in steel pipes. The range and frequency used in are relatively large.

High-precision cold drawn steel pipes will not rust according to the processing steps and processing procedures, but due to improper maintenance and improper maintenance, the use of cold drawn steel pipes is also rusty in life. of. The specific reasons are as follows:

High-precision cold drawn steel pipes have the ability to resist oxidation, and also have the ability to corrode in media containing acid, alkali and salt. However, the size of its corrosion resistance varies with the chemical composition of the steel of the high-precision cold-drawn steel pipe, the state of addition, the use conditions and the type of environmental media.

High-precision cold drawn steel pipe is a kind of steel pipe, which is processed by multiple cold drawing during the process of expanding the diameter of the blank or raw pipe. It is usually carried out on a single-chain or double-chain cold drawing machine of 0.5 to 100T. .

The outer diameter of high-precision cold drawn steel pipes can reach 6mm, the wall thickness can reach 0.25mm, and the outer diameter of thin-walled pipes can reach 5mm. The wall thickness is less than 0.25mm. The precision and surface quality are better than hot-rolled (expanded) pipes. Restrictions, its caliber and length are restricted.

Production diameter range: 16MM-219MM.

Production wall thickness range: 2.5MM-40MM.

Production length range: 5 meters-9 meters or more.

The mechanics principle of high-precision cold drawn steel pipes: during cold drawing, the steel pipe undergoes plastic deformation through the shape and size of the mold under the action of force. At present, the drawing methods in production can be roughly divided into three types: reduced-diameter drawing, reduced outer wall drawing and reduced inner wall drawing. During cold drawing, the steel pipe is subjected to drawing force, positive pressure and friction. Corresponding deformations mostly go through the three stages of diameter reduction, wall reduction and sizing, and corresponding stresses are generated in the deformation zone. The axial direction is tensile stress, the radial and circumferential directions are compressive stresses. The metal is in one direction during the process of drawing. Tensile and two-directional compressive stress states, which are the basic mechanical characteristics of the deformation process of cold drawn steel pipes.

https://www.skivingtubelw.com/

Send Inquiry